Tektronix 1760 - Manual (Page 86)

Using the Menus
1760 Series Component Waveform/Vector Monitor User Manual
3-18
Preset Menu
The 1760--Series has 10 presets capable of storing front-panel
setups. Nine of the presets are user-programmable and one is
factory pre-programmed.
Factory-programmed setup: WAVEFORM DISPLAY, CH-A
INPUT, DC REST ON, 10 µ s SWEEP, REF internal , and menus
off.
Push the PRESET menu button to access the on-screen menu,
illustrated in Figure 3-5. Turn the left bezel control to select
the
PRESET location to be acted on (presets 1--9 are available
through the menu). Next, use the bezel button corresponding
to the desired action
(RECALL, STORE, RENAME, OR RECOV-
ER). When a bezel button is pushed, a box flashes momen-
tarily around the on-screen label to verify that the selection
has been made.
VERTPOS HORIZPOS
CLEAR
MENU
Bezel
Buttons
Left Center Right
PRESET 1
PRESET 2
PRESET 3
PRESET 4
PRESET 5
PRESET 6
PRESET 7
PRESET 8
PRESET 9
FACTORY
RECALL
STORE
RENAME
RECOVER
Figure 3-5. The PRESET menu display.