ZyXEL Communications IP PBX X6004 - Manual (Page 175)

Chapter 7 Auto Provision
X6004 User’s Guide
175
Each field is described in the following table.
Table 35 Auto Provision > Edit
LABEL DESCRIPTION
Auto Provision
Profile Setting These settings apply to the phone number (extension) you specified in
the Auto Provision screen.
MAC Address Specify the MAC address of the ZyXEL device that receives
configuration settings from the X6004 for this extension.
This field is left blank for extensions assigned to software based IP
phones.
Serial No. Specify the serial number of the software based IP phone that receives
configuration settings from the X6004 for this extension.
This field is left blank for extensions assigned to hardware based IP
phones.
Auto Provision
Active Choose On, if you want to activate auto provisioning for this extension
or choose Off if you want to deactivate auto provisioning for this
extension.
Auto Provision
Interval Time Specify the amount of time in seconds to have SIP clients wait before
the next time of provision file downloading from the X6004. Enter the
time range between 21600 to 604800 seconds (between 6 to 168
hours). The default value is 43200 seconds (12 hours).
Auto Provision
Delay Time If many SIP clients download auto-provisioning files from the X6004 at
the same time, the X6004 may be overloaded. The total interval
between auto provisioning file downloads is the interval time plus the
delay time. For example of SIP phone A has the interval time of 10
hours and delay time of 10 seconds, the next auto provisioning
download will be 10 hours and 10 seconds later.
Select 1~30 seconds or leave it as default, Random, which is to have a
random delay time of between 1 to 30 seconds for each SIP client.
ATA device Select this if the ZyXEL device to which you are sending this
configuration file is an ATA device. An ATA (Analog Telephone Adapter)
device typically has multiple analog telephones connected to it and can
have unique configuration files for each port that it supports.
Port No. Specify the ATA phone port number that you want to create this
configuration file for.
Set Profile Click Set Profile to create the configuration file and return to the Auto
Provision screen.
Cancel Click Cancel to go back to the Auto Provision screen without saving
any changes.