ZyXEL Communications IP PBX X6004 User Manual
Page 182
Chapter 7 Auto Provision
X6004 User’s Guide
182
Firmware
Upgrade
Confirm
Select Enable to prompt IP phone users in their IP phone LCDs to
confirm a firmware upgrade or not. IP phone users are prompted as
soon as their phones log into the network when a firmware upgrade is
available.
Select Disable to turn this function off, allowing all IP phones
connected to the X6004 to upgrade themselves without user
intervention.
Note: This feature is disabled by default.
Firmware
Upgrade Start
Time
Enter the hour and minutes that the firmware upgrade is to begin. If
you use this option, you must also set a corresponding Firmware
Upgrade End Time to complete the time range.
During this time range, each phone on the network randomly sets a
time between the start time and the end time in which to connect to the
FTP server and upgrade itself.
Note: This option only works when the Firmware Upgrade
Confirm setting has been disabled.
Firmware
Upgrade End
Time
Enter the hour and minutes that the firmware upgrade is to end. If you
use this option, you must also set a corresponding Firmware Upgrade
Start Time to complete the time range.
During this time range, each phone on the network randomly sets a
time between the start time and the end time in which to connect to the
FTP server and upgrade itself.
Note: This option only works when the Firmware Upgrade
Confirm setting has been disabled.
Apply
Click this to save your changes.
Reset
Click this to set every field in this screen to its last-saved value.
Table 40 Auto Provision > Auto Firmware Upgrade (continued)
LABEL
DESCRIPTION