ZyXEL Communications P-202 - Manual (Page 102)

P-202H Plus v2 Support Notes
dcp fsm sw [on|off]
To enable/disable the NetCAPI state machine, use the dcp fsm sw [on|off]
command.
dcp fsm disp
To display the NetCAPI state machine log, use the dcp fsm disp command.
The following example shows the output of the dcp fsm disp command:
ISDN_DCP FSM Log, Entries = 6
Format
# TimeStamp Protocol ObjectID State Event Event Handling Function
0:00:03.190 DCP: 0 S:IDLE(01) E:CapREQ (00) Func:DCPIgnore
1:00:03.215 SC : 0 S:IDLE(01) E:STARTREQ (01) Func:DCPSCStartReq
2:00:04.375 SC : 1 S:ACTI(02) E:ENDREQ (02) Func:DCPSCEndReq
3:00:06.545 DCP: 0 S:IDLE(01) E:CapREQ (00) Func:DCPIgnore
4:00:06.555 SC : 0 S:IDLE(01) E:STARTREQ (01) Func:DCPSCStartReq
5:00:07.245 CC : 1 S:IDLE(01) E:LISTENREQ(05) Func:DCPListenReq
dcp fsm clear
To clear the NetCAPI state machine log, use the dcp fsm clear command.
dcp trcp sw on [on|off]
To enable/disable the NetCAPI packet log, use the dcp trcp sw on [on|off]
command.
dcp trcp disp
To display the NetCAPI packet log, use the dcp trcp disp command.
The following example shows the output of the dcp trcp disp command:
ISDN_DCP Message Log, Entries = 12
Format 1
Time Stamp Object ID MessageNum Parameter Length Message ID
TIME:23043.188 Obj:00000000 MNum:0x0 Len=0000
DCP_CAPABILITY_REQ(0000)
Format2
Time Stamp Object ID MessageNum Parameter Length Message ID
TIME:23043.188 Obj:00000000 MNum:0x0 Len=0025
DCP_CAPABILITY_CONF(0001)
Parameter Part
00 01 03 01 02 03 01 00 00 00 00 01 05 5a 79 58
45 4c 01 00 0e 50 72 65 73 74 69 67 65 20 32 30
All contents copyright © 2006 ZyXEL Communications Corporation.
102