ZyXEL Communications P-202 - Manual (Page 35)

P-202H Plus v2 Support Notes
7. Does Sentinel support IP range?
No, only subnet/single is supported. So when connecting with P-202H Plus v2,
please not use range as address type.
8. Does Sentinel support 2 VPN connections at the same time?
No, Sentinel doesn’t support it. Only one VPN connection can be activated at the
same time.
9. What is this option, “Attach the selected values to proposal only” for?
To increase compatibility, Sentinel sends many kinds of possible proposal for it’s
peer side, say P-202H Plus v2 to choose. If you uncheck this option, Sentinel will
only send out the proposal you configured. To decrease negotiation time, you
can uncheck this option, and verify phase1/phase2 parameters are consistent on
both sides.
10. How to initiate a VPN tunnel from Sentinel?
Right click SSH icon in system tray, click the VPN connection you have setup in
Select VPN. Packets triggering doesn't work in this case.
11. Can P-202H Plus v2 be the initiator of VPN tunnel to Sentinel?
No. Sentinel is supposed to be a VPN solution for remote access. Please always
initiate your VPN tunnel from Sentinel but not from P-202H Plus v2.
12. How can I verify if the VPN connection is up in Sentinel?
You can check if your VPN connection is up by double clicking SSH icon in
system tray. If the connection is up, you should see your VPN network in the
popped out window.
13. I am using EnterNet 300, a PPPoE dial up software. Any concern?
If using EnterNet PPP over Ethernet client, the network access type must be set
from the client’s advanced connection settings to protocol driver. Open Enternet
300 Profiles window -> Connections -> Settings -> Advanced -> In Network
Access section choose Protocol Driver.
Application Notes
All contents copyright © 2006 ZyXEL Communications Corporation.
35