ZyXEL Communications P-202 - Manual (Page 404)

P-202H Plus v2 Support Notes
IpxMatch 0 IpxDefaultMatch 0
IpxDefaultNotMatch 0 IpxPacketType 0
IpxDestNetwork 0 IpxDestNode 0
IpxDestSocket 0 IpxSourceNetwork 0
IpxSourceNode 0 IpxSourceSocket 0
3. Start a PING or start the traffic from the LAN side to trigger the outcall, and
then display the
filter counters again. If the 'Drop' field show some numbers there, then it means
that the packet
has been filter out, so no outcall was made when the packet was sent to the P-
202H Plus v2.
4. Reset to default configuration file
There are two cases you need to upload the default configuration file to the P-
202H Plus v2, they are:
1. You forget the SMT password and want to reset the password to 1234.
2. You want to reset the configurations to defaults.
Please note that the default configuration file for the new ZyNOS is not
compatible with the one for previous ZyNOS versions. So when upgrading your
Pretige from the previous ZyNOS to please also update the default configuration
file for the new ZyNOS.
• The procedure for uploading the configuration file via the console
port is as follows.
a. Enter debug mode when powering on the P-202H Plus v2 using a terminal
emulator
b. Enter 'ATUR3' to start the uploading.
c. Use X-modem protocol to transfer the configuration file.
d. Enter 'ATGO' to restart the P-202H Plus v2.
• The procedure for uploading the configuration file using TFTP client
program via LAN is as follows.
a. Use the TELNET client program in your PC to login to your P-202H Plus
v2.
All contents copyright © 2006 ZyXEL Communications Corporation.
404