ZyXEL Communications P-202 - Manual (Page 48)

P-202H Plus v2 Support Notes
o
IP Address-the IP address assigned to the workstation itself
o Subnet Mask-the subnet mask used for your network. Class C
networks generally use a 24-bit netmask DNS (Domain Name
Server) Address-enter the IP address of the DNS server
o
Default Gateway-the IP address of the P-202H Plus v2, the default
gateway for LAN1 is P-202H Plus v2 1 and for LAN2 is P-202H
Plus v2 2.
The procedure for configuring these parameters for the workstations may differ
depending on the type of TCP/IP networking software you are using on your
workstations. If you are unfamiliar with how to set these parameters, you can
refer to the technical notes corresponding to your software.
For Windows 9x, please go to 'Win9x>Control Panel>Network>TCP/IP-Network
Adapter' for finishing the above settings.
• Setting up the P-202H Plus v2 1 & P-202H Plus v2 2
Before configuring the two remote nodes for this application, you need to
complete the following settings first in each P-202H Plus v2.
o
General Setup in SMT Menu 1-enter the system information.
o ISDN Setup in SMT Menu 2- configure the ISDN parameters.
o
Ethernet Setup in SMT Menu 3-enter the IP address of the P-202H
Plus v2 and enable the DHCP server if it is required.
o
Remote Node Setup in SMT Menu 11
• P-202H Plus v2 1 Setup
1. Ethernet Setup in SMT Menu 3
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
DHCP Setup:
DHCP= None
Client IP Pool Starting Address= N/A
Size of Client IP Pool= N/A
Primary DNS Server= N/A
Secondary DNS Server= N/A
TCP/IP Setup:
IP Address= 202.113.5.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
All contents copyright © 2006 ZyXEL Communications Corporation.
48