ZyXEL Communications P-202 - Manual (Page 403)

P-202H Plus v2 Support Notes
p2864> ip route errcnt disp
last route error code = a <--an hex value index point to the last error
ipRouteFail_Disable 0 (index 0) ipRouteFail_PktLen 0(index1)
ipRouteFail_Header 0 (index 2) ipRouteFail_CkSum 0
ipRouteFail_OptLen 0 ipRouteFail_OptSRoute 0
ipRouteFail_OptSSRoute 0 ipRouteFail_OptRRoute 0
ipRouteFail_TTL 0 ipRouteFail_No_Route 0
ipRouteFail_Wan_Route 3 <-+ ipRouteFail_RtType 0
ipRouteFail_DF 0 | ipRouteFail_Fragment 0
|
| This counter is increased by 1
This ipRouteFail_Wan_Route means routing cannot get a WAN resource to dial
out. You can go to Menu 24.1 and verify if both B channels are up already or if
the Link is 'Down'.
< Example >
1. If the routing table show the 'Use' is the same as before the PING. ( Or any
other traffic that you think should route and trigger the outcall. ) Furthermore, the
error counters are still 0's.
P-202H Plus v2> ip route st
Dest FF Len Interface Gateway Metric stat Timer Use
204.247.203.191 00 32 en0if 204.247.203.183 1 0015 0 0
204.247.203.128 00 26 wanIdle 204.247.203.167 2 0023 0 0
100.0.0.0 00 8 wanIdle 100.1.1.1 2 0023 0 3
default 00 0 wanIdle Internet 2 0023 0 0
2. You may want to verify if you have plugged in any filters for that remote node
or LAN.
P-202H Plus v2> sys filter sw on
P-202H Plus v2> sys filter disp
Drop 0 Forward 0
SetNotConfig 0 SetNotActive 0
NonRuleMatch 0 InvalidSet 0
GenMatch 0 GenNotMatch 0
IpMatch 0 IpDefaultMatch 0
IpDefaultNotMatch 0 IpSourceAddr 0
IpDestAddr 0 IpSourceRoute 0
IpTcpConn 0 IpSourcePort 0
IpDestPort 0 IpProtocol 0
All contents copyright © 2006 ZyXEL Communications Corporation.
403