ZyXEL Communications P-202 User Manual
Page 56
P-202H Plus v2 Support Notes
Allocated Budget(min)= 0
Period(hr)= 0
Press ENTER to Confirm or ESC to Cancel:
•
The Recv Authen field should be set to the type of authentication protocol
you want to use.
•
Since the workstation needs to have its IP address assigned, set the IP
Address Supplied By: Dial-in User field to 'No'.
•
Make sure that IP Pool is set to 'Yes'.
•
In IP Start Addr, enter the IP address that you want to assign to the
workstation when it dials in. In our example, this would be '192.68.135.10'.
•
All the common properties in Menu 13 will be applied to all dial-in users.
Note: If the remote user uses the Win9x to dial in, the Recv Authen must
be set to PAP because Windows 9x will not respond to any periodic CHAP
challenge sent by the P-202H Plus v2 and will cause the P-202H Plus v2
to drop the call.
3. Edit Dial-in User Setup in SMT menu 14.1
•
Dial-in user without callback
Menu 14.1 - Edit Dial-in User
User Name= abc
Active= Yes
Passwd= *********
Callback= No
Phone # Supplied by Caller= N/A
Callback Phone #= N/A
Rem CLID=
Idle Timeout= 100
All contents copyright © 2006 ZyXEL Communications Corporation.
56