ZyXEL Communications P-202 - Manual (Page 338)

P-202H Plus v2 Support Notes
Intel VPN client to P-202H Plus v2 Tunneling
This page guides us to setup a VPN connection between the Intel VPN client
software and P-202H Plus v2 router. There will be several devices we need to
setup for this case. They are Intel VPN software and P-202H Plus v2 router.
As the figure shown below, the tunnel between PC 1, with Intel VPN client
installed, and P-202H Plus v2 ensures the packets flow between them are secure.
Because the packets go through the IPSec tunnel are encrypted. To setup this
VPN tunnel, the required settings for Intel VPN client and P-202H Plus v2 are
explained in the following sections. As the red pipe shown in the following figure,
the tunneling endpoints are Intel VPN client and P-202H Plus v2.
The IP addresses we use in this example are as shown below.
PC 1 P-202H Plus v2 PC2
172.21.1.232
LAN: 192.168.1.1
WAN: 172.21.1.252
192.168.1.33
1. Setup Intel
1. Select Tunnels/New.../IPSEC Tunnel to create a VPN connection.
All contents copyright © 2006 ZyXEL Communications Corporation.
338