Xerox 490 - Manual (Page 104)

Printer Management Xerox 490/980 Color Continuous Feed Printing System
7-14 Printer & PC GUI Guide
Printer Configuration Tab
The Printer Config tab allows changing between single and duplex printer configuration.
The printer configuration cannot be changed when there is an active job. It can be changed
only in paused state.
• Device List: Displays the list of devices that can be set in the printer configuration. On this
version, one printer is displayed. The displayed contents are as follows.
• Vendor Name: The device manufacturer name is displayed.
• Type: The device type is displayed.
• Printer Name: The printer name is displayed.
• IP Address: The IP address is displayed.
• Device display area: Select a device from the device list, and the icon for the selected
device appears.
• Configuration display area: Drag an icon displayed in the device display area to the
desired position in the configuration display area. It is possible to rearrange the icons in this
area to change the printer configuration
Operating buttons
• Setting: Sets the modified contents. Select [Yes] on the confirmation screen to enable the
Configuration Change End. Select [No] to cancel the operation.
• Configuration Change End: Select [Setting] to enable this button. Select [Yes] on the
confirmation screen to shut down the printer. Select [No] to cancel the operation.
• Reset: The operation is cancelled and the initial value information is shown.
• Recycle Setting: Disconnects the device in the configuration display area. Dragging the
device icon in the configuration display area and dropping it on the icon will disconnect the
configuration.