Xerox 490 - Manual (Page 21)

Xerox 490/980 Color Continuous Feed Printing System PC-GUI Introduction and Setup
Printer & PC GUI Guide 1-9
Service Mode
Select the Service Mode allows you to view controller information, collect logs and other service
related functions. From the System menu, select [Service Mode....] to open the Logon dialog
box.
Type the correct password, the Service Mode dialog box will appear.
Check with your Xerox customer service representative for the password needed to invoke
Service Mode. To close the Service Mode dialog box, select the [x] in the upper right corner of
the console screen or select [Close].
Logging tab
Select [Start] in the Service Mode dialog box to start logging trace information and save it to
the location specified by the Save To destination. On a duplex configuration, the upstream and
downstream logs are automatically collected.
• Save to: The log can be saved to any drive that is connected to the remote PC. Remember
the name of the drive before saving the log to a hard disk drive that is attached to the
remote PC.
• Start: Select [Start] to start logging to the selected folder.
• Stop: Select [Cancel] to cancel logging after it has started. Logging is canceled and the
processing will stop.
• Close: Select [Close] to exit the operation and close the dialog box.