Xerox 490 - Manual (Page 129)

Xerox 490/980 Color Continuous Feed Printing System Queue Management
Printer & PC GUI Guide 8-17
New Queue PS Options
The default values to be used for PostScript data printing can be set.
• Resolution: Fixed at 600 x 600.
• Copies: The number of copies can be set in a range from 1 to 32,767.
An error occurs when the output process mode is in spool, or the output process mode is in
stream exceeding 9,999. The maximum number of reports to be loaded simultaneously in the
output spool is 9,999.
• Overwrite: Place a check mark in this checkbox to prioritize the number of copies set in the
properties over the number of copies set in the lpr command. When this checkbox is
unchecked, the number of copies set in the lpr command are used.
When overwriting is active, the priority for the number of copies follows the order below:
Copies in the queue > -# copies or –C# copies
• Document Type: Not available in this version.
• Page Size: The page size for image data can be set as any of the following.
A3, B4, A4, B5, A5, Letter, Legal, LEDGER, and Non-standard
• Width/Length: Enabled when non-standard is specified as the page size. The setting range
is as follows according to the selected unit.
• Unit: Any of inch, millimeter, and dot can be selected.
• Halftone Setting: The halftone setting is displayed according to the specified job
resolution.
Unit Width Length
Inch 1.0 to 19.5 1.0 to 19.5 (When extended option exists: 28.0)
Millimeter 25.4 to 495.3 25.4 to 495.3 (When extended option exists: 711.2)
Dot 600 to 11700 600 to 11700 (When extended option exists: 16800)