Xerox 490 - Manual (Page 110)

Printer Management Xerox 490/980 Color Continuous Feed Printing System
7-20 Printer & PC GUI Guide
Mark Tab
You can specify whether to print ROF marks and the number of adjustment prints. You can
make the settings when the printer is paused.
Setting side of forced ROF mark
You can specify the surface on which ROF marks are to be printed.
• Front side: Prints ROF masks on the top surface of paper.
When using a duplex printing system, ROF marks are always printed independent of the
selection for Setting side of forced ROF mark and ROF mark print in job print.
• Back side: Prints ROF masks on the back surface of paper.
When using a simplex printing system, the setting for “?” is invalid.
ROF mark print in adjustment print
You can specify whether to print ROF marks during adjustment print and the number of prints.
• Enable: Prints ROF marks. Setting for Copies is enabled.
• Disable: Does not print ROF marks. Setting for Copies is disabled. The default for Copies is
used.
The default number of adjustment prints is 100.
• Copies: Specify a value in the range from 10 to 255. The number of prints will be 10 times
the set value.
If you specify 10, the number of prints will be 100.
ROF mark print in print end
You can specify whether to print ROF marks when printing is finished and the number of prints.
• Enable: Prints ROF marks. Setting for Copies is enabled.
• Disable: Does not print ROF marks.
The default number of adjustment prints is 100.
• Copies: Specify a value in the range from 10 to 255. The number of prints will be 10 times
the set value.
If you specify 1, the number of prints will be 10.
ROF mark print in job print
You can specify whether to print ROF marks at the time of job printing.
• Enable: Prints ROF marks.
• Disable: Prints ROF marks.