Yamaha HTR-6090 - Manual (Page 115)

111
En
REMOTE CONTROL FEATURES
AD
V
ANCED
OPE
R
A
T
IO
N
■ Clearing a macro function
You can clear the function programmed for a certain
macro button.
1
Set the operation mode selector to AMP or
SOURCE and then press MACRO using a
ballpoint pen or similar object.
“MCR ?” appears in the display window on the
remote control.
If you do not complete each of the following steps within 30
seconds, the macro programming mode will be
automatically canceled. In this case, start over from step 1.
2
Press and hold CLEAR using a ballpoint pen
or similar object, then press the macro
button you want to clear for about 3 seconds.
“C;OK” appears in the display window on the remote
control if clearing was successful.
y
• If you continuously want to clear another function, repeat
step 2.
• Once you clear a programmed function, the button reverts
to the factory setting (or to the manufacturer setting if you
have set remote control codes).
3
Press MACRO again to exit the macro
programming mode.
• “C;NG” appears in the display window on the remote control if
clearing was unsuccessful. In this case, start over from step 2.
• “ERROR” appears in the display window on the remote control
if you press more than one button simultaneously.
Note
MACRO
TV
SOURCE
AMP
TV
SOURCE
AMP
or
Notes
ON OFF CLEAR LEARN RENAME MACRO
V-AUX/DOCK
DTV DVR/VCR 2 VCR 1 DVD
CBL/SAT MD/TAPE CD-R
01EN_00_HTR-6090_U.book Page 111 Tuesday, June 27, 2006 6:40 PM