Yamaha HTR-6090 - Manual (Page 90)

86
En
CUSTOMIZING THIS UNIT (MANUAL SETUP)
5
Press k / n repeatedly and then press ENTER
to select and enter the desired submenu.
The following display is an example where “LFE
LEVEL” is selected.
6
Press k / n to select the desired parameter
and then l / h to change the parameter
settings.
• Press h to increase the value.
• Press l to decrease the value.
7
Press SET MENU to exit from “SET MENU”.
Use this menu to manually adjust any speaker settings.
■ Speaker settings
A)SPEAKER SET
Use this feature to manually adjust any speaker settings.
y
• If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
• When the diameter of the woofer section of the speaker unit is
larger than 16 cm (6.5 in), set the correspondent speaker setting
parameter to “LARGE” (or “LRG”).
LFE/Bass out LFE/BASS OUT
Use this feature to select the speakers that output the LFE
(low-frequency effect) and the low-frequency signals.
Choices: SWFR, FRONT, BOTH
• Select “SWFR” (subwoofer) if you connected a
subwoofer. The LFE signals as well as the low-
frequency signals of other speakers set to “SML” (or
“SMALL”) are directed to the subwoofer.
• Select “FRONT” (front) if you did not connect a
subwoofer. The LFE signals, the low-frequency signals
of the front left and right channels, and the low-
frequency signals of other speakers set to “SML” (or
“SMALL”) are all directed to the front left and right
speakers regardless of the “FRONT SP” setting (see
page 86).
• Select “BOTH” (both) if you connected a subwoofer.
The low-frequency signals of any source are output
from the subwoofer. The LFE signals as well as the
low-frequency signals of other speakers set to “SML”
(or “SMALL”) are directed to the subwoofer. The low-
frequency signals of the front left and right channels
are directed to the front left and right speakers and the
subwoofer regardless of the “FRONT SP” setting (see
page 86).
. SPEAKER;;;;;;0dB
HEADPHONE ;;;;0dB
[ ]/[ ]:Up/Down
[ ]/[ ]:Adjust
B)LFE LEVEL
p
p
p [
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
MENU
SRCH MODE
SET MENU
1 BASIC MENU
. A)SPEAKER SET
B)SP LEVEL
C)SP DISTANCE
D)TEST TONE
2 BASIC MENU
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
SWFR FRONT BOTH
LFE/BASS OUT
[
01EN_00_HTR-6090_U.book Page 86 Tuesday, June 27, 2006 6:40 PM