Yamaha HTR-6090 - Manual (Page 40)

36
En
AUTO SETUP
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
“RESULT:EXIT” display. Check the warning messages to
correct your speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2
Press l / h repeatedly to toggle between the
warning displays.
y
• For details about each warning message, see the “AUTO
SETUP” section in “TROUBLESHOOTING” on
page 128.
• When the corresponding warning message is not
applicable to a speaker, “– –” is displayed instead.
3
Press ENTER to return to the top
“RESULT:EXIT” display.
Note
RESULT:EXIT
. WARNING (3)
RESULT
. SP : 5/4/0.1
. DIST: 14.0/ 17.0ft
. LVL : -9.0/ +6.5dB
[SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
WARNING: W-1
< OUT OF PHASE >
Reverse Channel
FL
--
CENTER
PL
PR
SL SR
SBL SBR
[ ]/[ ] : Select
[ENTER] : Enter p [
ENTER
A-E/CAT.
PRESET/CH
RESULT:EXIT
WARNING (3)
RESULT
. SP : 5/4/0.1
. DIST: 14.0/ 17.0ft
. LVL : -9.0/ +6.5dB
. SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
[
01EN_00_HTR-6090_U.book Page 36 Tuesday, June 27, 2006 6:40 PM