Yamaha HTR-6090 - Manual (Page 124)

120
En
ADVANCED SETUP
4
Press the numeric buttons to enter the four-
digit remote control code for the input area
you want to use.
Remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the input area you want to use.
You need to set the corresponding remote control AMP ID
(see page 118).
5
Press ENTER to set the number.
“OK” appears in the display window if setting was
successful.
“NG” appears in the display window if the setting
was unsuccessful. In this case, start over from step 1.
6
Press LEARN again to exit from the setup
mode.
■ Setting remote control tuner ID or XM ID
1
Set the operation mode selector to AMP or
SOURCE and then press TUNER or XM on
the remote control to select the tuner or XM
to change the remote control ID.
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
then l / h repeatedly until “L;TUN” and
“TUNER”, or “L;TUN” and “XM” alternately
appear in the display window on the remote
control.
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3
Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
AMP library
code
(remote control
setting)
Function
Remote
control AMP
ID
2001
(initial setting)
To operate this unit using the
default code. ID1
(initial setting)
2002
To operate this unit using an
alternative code.
ID2
Note
4 3 2
0 9
5
1
7 6 8
STEREO SUR. DECODE SELECT EXTD SUR.
CLASSICAL LIVE/CLUB ENTERTAIN MOVIE
ENTER
A-E/CAT.
PRESET/CH
LEARN
Notes
XM
TUNER
TV
SOURCE
AMP
TV
SOURCE
AMP
or or
LEARN
ENTER
A-E/CAT.
PRESET/CH
ENTER
A-E/CAT.
PRESET/CH
01EN_00_HTR-6090_U.book Page 120 Tuesday, June 27, 2006 6:40 PM