Rorke Data Galaxy HDX2 GHDX2-2430S-24F4D User Manual
Page 102
Chapter 5: Subsystem Maintenance
Subsystem Maintenance
5-7
Step 2.
Install the BBU module onto the replacement controller. You
may need to install a DIMM module to your replacement
controller if it comes without a pre-installed module.
Step 3.
Install the replacement controller into the subsystem by
pushing it into the module slot. Carefully push it in until you
feel the contact resistance. Use slightly more force and when
the controller faceplate is almost aligned with the chassis rear
panel, pull up the ejection levers to secure the controller into
chassis.
Figure 5-4: Installing a Replacement Controller
Step 4.
Fasten the previously removed retention screws to secure the
ejection levers.
Step 5.
Re-attach all the cables that were removed. These include the
host FC cables, SAS expansion link, the Ethernet cable, and
the serial port cables.