Rorke Data Galaxy HDX2 GHDX2-2430S-24F4D - Manual (Page 51)

Chapter 2 Hardware Installation
Hardware Installation 2-19
2.9. Drive Tray Installation
Before drive tray installation, you need to access the drive bays on the left- and right-side
columns:
To access drive bays hidden behind the forearm handles, first release the retention latches
on the enclosure front handles, and then swing the handles to the left and right-hand
sides. To close the handles, see Figure 2-16, first swing the handles towards the center to
reveal the retention latch, release the latch, and then close the handles.
Figure 2-16: Closing the front handles
Install the drive trays into the subsystem once the hard drives have been installed in the
drive trays.
Step 1. Use a flat blade screwdriver to turn the rotary bezel lock to the
unlocked position, i.e., the groove on its face is in a horizontal
orientation. If the groove is in a vertical position, then the bezel lock is
locked and the front bezel cannot be opened.
Figure 2-17: Drive Tray Front Bezel
Step 2. Open the front bezel by pushing the release button. The front bezel
will automatically swing open.
Clip