Rorke Data Galaxy HDX2 GHDX2-2430S-24F4D - Manual (Page 11)

Galaxy Raid Installation and Hardware Reference Manual
xi
Safety Precautions
Precautions and Instructions
• Prior to powering on the subsystem, ensure that the correct power range is being
used.
• The Galaxy subsystem comes with twenty four (24) drive bays. Leaving any of these
drive bays empty will greatly affect the efficiency of the airflow within the
enclosure, and will consequently lead to the system overheating, which can cause
irreparable damage.
• If a module fails, leave it in place until you have a replacement unit and you are
ready to replace it.
• Airflow Consideration: The subsystem requires an airflow clearance, especially at
the front and rear.
• Handle subsystem modules using the retention screws, eject levers, and the metal
frames/face plates. Avoid touching PCB boards and connector pins.
• To comply with safety, emission, or thermal requirements, none of the covers or
replaceable modules should be removed. Make sure that during operation, all
enclosure modules and covers are securely in place.
• Be sure that the rack cabinet into which the subsystem chassis will be installed
provides sufficient ventilation channels and airflow circulation around the
subsystem.
• Provide a soft, clean surface to place your subsystem on before working on it.
Servicing on a rough surface may damage the exterior of the chassis.
• If it is necessary to transport the subsystem, repackage all disk drives separately.
• Dual redundant controller models come with two controller modules that must be
installed into the subsystem. Single controller modules come with a single controller
module and a metal sheet is placed over the lower controller bay at the rear of the
subsystem. Since single controller modules cannot be upgraded, this metal sheet
should NEVER be removed.
ESD Precautions
Observe all conventional anti-ESD methods while handling system modules.
The use of a grounded wrist strap and an anti-static work pad are recommended.
Avoid dust and debris in your work area.