EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 117)

Specific Behavior
• One can set as many swap points as needed.
• If only an IN swap point is set for one clip, the audio tracks will be reset by default for
the next clip in the playlist.
• When a swap point is set, a cross-fade is played between the original audio track and
the new track. The duration of the cross-fade is the default audio transition.
• When a swap point is present in a playlist, the display on the VGA and on the OSD
changes: a “*” is added next to the audio Fx information:
Display
Display on the VGA:
The swap function can only be used on the Remote Panel. The playlist display on the
VGA will however look like this after a swap point has been set:
Display on the OSD:
*PL11/03* LEFT 06:42:22
V Mix 02:25 Spd.Unk
A Mix*02:25 A.Del. 00:00
IN-00:00:00 OUT+00:00:27
LOOP:
12:23:45:13 00:07:13 100
112B/04 ClipName 999/999
Swapping Audio Track in Manual Mode
If the Manual mode is selected for the Swap audio tracks parameter value in the
Operational Setup menu (p.3.2 F4), the swap operates in a similar way but asks the
operator which track to swap when setting the swap points.
1. Select the original track:
◦ In 2-Track mode: select between the tracks 1,2 or MENU to cancel.
◦ In 4-Track mode: select among the tracks 1 to 4, or MENU to cancel.
◦ In 8-Track mode: select among the tracks 1 to 8, or MENU to cancel.
◦ In 16-Track mode: select among the tracks 1 to 16, or MENU to cancel. The
tracks 1-8 are displayed on the first page and the tracks 9-16 are available via F10
on the second page.
◦ Use the function keys to select the track to change.
OPERATION MANUAL Multicam LSM 11.02
5. Playlist Management 107