EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 165)

PGM1 Cam A *PRV1* Cam B
Push PgmSpd Sw To In Pref
>Archive *** Name Cam
P.1 B.1 Clips: Local Records: Local
PL 11: < >
Msg:
*** Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
The SHIFT+A function of the main menu, normally used by the Reset CAM function, can
be used to define the ranking, without entering the secondary menu.
For additional functions like selecting keywords, flagging the future clip for archiving,
marking it to be pushed to another machine, defining its name from the keywords, they
can be performed from the secondary menu, exactly the same way as for a clip already
stored.
All these settings are memorized and will be applied to the clip when it is created.
Assigning Keywords in Numeric Mode
To assign keywords to a clip in numeric mode, recall the clip, then press MENU to access
the secondary clip menu on the Remote Panel.
1 player_B10123 2 action_
689012 3 keyword8901
action_889012 111A
Enter keyword # 8 with F_ keys + ENTER
Push Aux Clip Sort->TC PostRoll
>Archive *** Name Cam
Enter the keyword position in the list using the F_ keys. Every time a new digit is entered,
the corresponding keyword is displayed in the highlighted area in the centre of the LCD
screen, to allow the operator to validate the entry before confirming it. If a wrong digit is
entered, press the CLEAR key to delete it. Once the right keyword is found, press
ENTER to confirm or MENU to cancel.
The rules for keyword assignment and deleting keywords are identical between LIST and
NUMERIC modes.
In the VGA Interface
Move the cursor to the desired keyword and press ENTER, or click on the keyword with
the stylus. The keyword will be assigned to the first available keyword location on the last
line of the screen. Repeat this to assign more keywords (up to 3) to the current clip.
Depending on the CLIP/CAM mode, the keywords will be assigned to the current camera
angle only (CAM mode), or to all camera angles of the current clip (CLIP mode).
If three keywords are already assigned to the clip, the operator has to clear some of them
to be able to assign new keywords.
OPERATION MANUAL Multicam LSM 11.02
7. Keyword Management 155