EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 22)

Function Key Use
F2: 2 Remotes Two Remote Panels are used in the configuration.
If 4 play channels are available, when selecting the 2 Remotes
mode, the operator can choose between two configurations:
• 2 play channels for each remote:
In this configuration, each Remote Panel can select
PGM+PRV or 2PGM mode. Each Remote Panel can
manage video transitions (cut, mix, wipe) in PGM+PRV and
playlist modes.
• 3 play channels for the 1 st remote and 1 play channel for the
second remote.
In this configuration, the 1
st
remote can select PGM+PRV or
3PGM mode and can manage video transitions. The 2 nd
remote is forced to 1PGM mode and can only handle cut
transitions.
F3: 3 Remotes Three Remote Panels are used in the configuration.
F4: 4 Remotes Four Remote Panels are used in the configuration.
F5: Char. On/Off Enables or disables the on-screen display (Timecode, Clip ID…)
on the output monitors.
F6: Exit Exits the Multicam software and returns to the EVS Menu.
F7: Clear all clips Clears all clips. All clips will be lost. A confirmation of this
command is required.
For more information to this action. "Deleting Clips" on page 57.
Note: This command is not similar to the Clear Video Disks from
the Maintenance menu. If you wish to refresh completely the
server, i.e. to clear all clips including the protected ones, you
need to use Clear Video Disks rather than Clear all clips.
F8: Stop Record Stops the record. The REC key will go off and the F8 function
key is now used to restart the record.
F9: Fill Playlist «Dump» feature which allows all clips to be «dumped» at the end
of the current playlist. This allows the operator to save all
material to tape, as a backup feature after a show is complete.
You can select in the Setup menu which camera angles have to
be included in the Fill Playlist function.
If your clips are currently connected to another server on the
network, the clips from that server will be added to your current
playlist.
Make sure that the playlist you have selected is an empty one.
This function will append the clips at the end of an existing
playlist.
F0: Technical
setup Gives access to the technical setup menu.
12 2. Working Interfaces
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013