EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 207)

Key Description
RECORD This key corresponds to the ‘ARM’ or ‘REC’ commands on
hypermotion cameras.
When you press RECORD for the first time, all the A/V material
recorded in the memory block(s) of the camera is deleted.
Please refer to the camera models specific features at the end of this
chapter for more information about the behavior of your camera when
pressing the RECORD key on a recording memory block.
TAKE This key corresponds to the ‘Trig/Stop Rec’ command on hypermotion
cameras.
With a single-block memory or when the last block is reached, press
TAKE to stop the recording.
With a multiple-block memory, press TAKE to stop the record on the
current block and automatically start the record on the first free block,
if available.
Lever There is no corresponding command on hypermotion cameras.
Press the Lever key to shift to the secondary lever range (defined in
the 2ndLever parameter in the hypermotion secondary menu) for
material played out using the hypermotion feature.
CAM Keys Press a CAM key corresponding to a recorded block to load the last
recorded frame of the selected block in play mode.
If you press a CAM key corresponding to an empty block, the remote
beeps.
CLEAR Press the CLEAR key to clear the recorded material on a block. It can
be used in the following ways:
• To clear the record on a given block that is not in PLAY mode,
press CLEAR and the CAM key corresponding to the requested
block.
• To clear the record on a block when the block is in PLAY mode,
press CLEAR. The PLAY is stopped, the recorded material is
deleted from the block, and the camera automatically starts
recording again in this block if it is not recording on any other block
yet.
Note
The CLEAR button is only active on some cameras.
Creating a Clip from a Hypermotion Camera
When the camera is replaying its content into the EVS server, you can clip it automatically
directly from the remote controlling the camera.
Use the IN and OUT keys and the F_ keys to clip the record train corresponding to the
hypermotion camera and to store it at a clip position. So you can clip the hypermotion
camera without having the control on a PGM, and without having to wait for all the content
to be recorded on the server.
OPERATION MANUAL Multicam LSM 11.02
9. Advanced Control Modes 197