EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 204)

Hypermotion Main Menu
The hypermotion main menu displays the memory blocks that have been selected in the
# Blocks parameter of the hypermotion secondary menu. The memory blocks use is
described later in this chapter.
Only the activated blocks will be displayed and the highlighted block is the one the
operator is currently working on.
Off Ramp UP LSM Mode
Block 1 Block 2
Cues Parameter
Off Ramp UP LSM Mode
Block 1 Block 2
The default value of the Cues parameter is On.
Last Cue Parameter
Off Ramp UP LSM Mode
Block 1 Block 2
The Last Cue parameter defines the Last Cue button function when the Cues value is Off.
• The Last cue parameter can be set to Ramp Up (the default value):
◦ The first time the Last Cue button is pressed, the speed is increased starting from
the PGMSpeed until the maximum speed is reached. This maximum speed
depends on the camera model.
◦ Whenever the Last Cue button is pressed again, the speed is increased starting
from the last speed used until the maximum speed is reached.
• The Last cue parameter can be set to an individual speed (the available values
depends on the camera model).
Note
• When Cues is set to Off, the cam key is displayed in black and the Mark
button is inactive.
• When Cues is set to Off and Last Cue is set to Ramp Up, press Clear+Last
Cue to reset the speed to PGMSpeed.
194 9. Advanced Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013