EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 35)

Aud.Met.
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
This option enables/disables the display of audio meters for all channels using the OSD of
the output monitors.
Post-Roll
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
When the post-roll mode is enabled, that function is highlighted on the LCD and a “P”
appears on the OSD of the output monitors.
When the user exits Multicam with the post-roll mode on, this mode will still be enabled
when Multicam is restarted.
The post-roll mode works as follows depending on the element played:
• When a clip is played, it will not stop on the Short OUT point, but will continue to play
through the Short OUT point by the post-roll duration defined in the Setup Menu.
• When a record train is played, the same will happen if the Record trains OUTs
parameter is set to “Freeze” in the Operational Setup menu (p.2.3 F1).
• When a playlist is played, the post-roll will apply only to the last clip of the playlist.
Sort->TC
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
This function allows the operator to search for all clips that contain a particular timecode.
See section "Remote Panel Functions" on page 38 for more information on this function.
Search
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
This function allows the operator to search the database using keywords and ranking.
"Keyword Management" on page 148.
To return to the operational menu, press the MENU key from the Remote Panel.
OPERATION MANUAL Multicam LSM 11.02
3. Control Modes 25