EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 99)

How to Add Clips at the End of the Current Playlist
You can create a playlist very quickly. The experienced operator can include a clip at the
end of the playlist containing an action that happened seconds before the playlist is played
on air. To add clips quickly at the end of the current playlist, you do not have to enter the
Edit mode.
To add clips to the current playlist, proceed as follows:
1. Activate a playlist as the current playlist.
2. Recall the first clip for your playlist.
3. Press ENTER on the Remote Panel.
The clip is added at the end of the current playlist.
4. Repeat as many times as necessary until the last clip is entered.
How to Insert Clips into a Playlist
The following rules apply to the procedure below:
• You need to be in PGM/PRV mode to be able to use the TAKE key on the Remote
Panel to insert a clip.
• Depending on what is selected for the Insert in playlist parameter in the Operational
Setup menu (p.3.1 F6), the clip will be inserted before or after this selected position.
To insert a clip into a playlist, proceed as follows:
1. Using the Playlist Edit mode or the Browse mode, scroll to the location where the clip
must be inserted.
2. Call the selected clip. It appears on the PRV output.
3. Do one of the following to insert the selected clip in the playlist, at the position shown
on the PGM output:
◦ Press the A key (Insert function) on the Remote Panel
◦ Press the TAKE key on the Remote Panel
◦ Press the SHIFT+INSERT keys on the Remote Panel
A confirmation message will appear if that option has been enabled in the Setup menu.
After the clip has been inserted, you can press PLST to return to the playlist at the current
position.
OPERATION MANUAL Multicam LSM 11.02
5. Playlist Management 89