EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual User Manual
Page 71
In the VGA Interface
Copying and moving clips is performed using the CUT, COPY and PASTE functions
available in the Clip Management area.
How to Copy a Clip
To copy or move a clip, proceed as follows.
1. Move the cursor to the clip to copy.
2. For a copy, press CTRL+C (COPY function) or for a move, press CTRL+X (CUT
function) or click on the corresponding area in the Clip Management area. During a
move operation, the original clip is deleted.
3. The clip is copied to the clipboard .The clipboard area displays its content: clip
number, network number if the copied clip is a remote one, and the selected cameras.
◦
In 'CLIP' mode: all camera angles of the clips will be copied.
◦
In 'CAM' mode: only the selected camera angle will be copied.
4. Move the cursor to the clip/playlist location where the content of the clipboard should
be copied.
For a LONG copy, where the entire original clip is copied, including its guardbands:
5. Press CTRL+V (LONG PASTE function) or click on the corresponding area in the
Clip Management area.
For a SHORT copy, where only the material between the Short IN and Short OUT points
of the original clip is copied, augmented by the duration of the destination default
guardbands:
6. Press CTRL+SHIFT+V (SHORT PASTE function) or click on the corresponding area
in the Clip Management area.
◦
In 'CLIP' mode: only the available camera locations inside the destination clip are
copied. If some camera angles already exist for the destination clip, they are not
be overwritten by the corresponding camera in the clipboard.
◦
In 'CAM' mode: the selected camera angle is copied.
7. During a move operation, the original clip is deleted.
Note
A “Cut & Paste” of a clip is equivalent to a “Move Clip”, meaning that any
reference to that clip inside playlists will be updated to the new location of that
clip. This is not the case when doing a “Copy & Paste”, then deleting manually
the original clip.
OPERATION MANUAL Multicam LSM 11.02
4. Clip Management
61