EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 129)

Video from the previous clip is extended and video from the clip being edited is shortened.
How to Add an Video Split
When you perform a video split, you specify the TC for the beginning or end of the video
transition. In this case, you can choose whether you perform an video delay or advance.
To add a video split, proceed as follows:
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press to highlight A Base (SHIFT+B)
4. Press to highlight V Split (D)
5. Jog to the point where you want to set your transition
6. Do one of the following:
◦ Mark an OUT point if you do a video delay.
◦ Mark an IN point if you do a video advance.
The value entered will be present on the PRV SCREEN when the clip is next to play in a
playlist.
Note
If the IN or OUT point is defined two clips before or after the current clip (or even
beyond), you will be asked to convert the playlist to a timeline.
IN Key Colors in Playlist Mode
• When the Playlist is sitting on the Video and Audio IN point of a Clip, the IN key will
light red.
• When the Playlist is sitting on the Video IN point of a Clip, the IN key will also light
red.
• When the Playlist is sitting on the Audio IN point of a Clip, the IN key will flash red.
• If the Playlist is in a position where the Audio and Video are synchronous, the IN/OUT
keys will be green.
• If the Playlist is in a position where the Audio and Video IN points have been split, the
IN key will flash green.
OPERATION MANUAL Multicam LSM 11.02
5. Playlist Management 119