EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 25)

IN
This function defines the IN point of a clip. The key will light differently depending on the
following situations:
• Green key The key lights green if an IN point exists but is not the image you see.
• Red key The key lights red if the on-air image is at this IN point. This point can be
entered while recording.
• Flashing (green or red) key In Split Audio mode, this key can be flashing green or
flashing red. "Using the Split Audio Mode" on page 109 for more details.
• During a Replace operation on a playlist, this key will flash red if trying to insert an IN
marker on a transition, as this is not allowed.
• During an Extend operation on a timeline, this key will flash red until you jog. At that
time, it will flash green until the operation is confirmed using the CAM D key.
Goto OUT
When you are in CLIP mode, this key combination enables the operator to go to IN / OUT
points of clips, instantly.
OUT
This function defines the OUT point of a clip. This operates similarly to the IN button.
Modification of Clip IN / OUT Points
Select the clip that you wish to modify, use the jog dial to position the material at the new
IN or OUT point, and re-mark the IN or OUT point(s) as required.
Warning
When IN/OUT points are set and a clip is saved, the system automatically
write-protects a user definable length of material before and after the IN/OUT
points respectively. These are referred to as the guardbands. Their duration can
be set with the Default clip duration parameter in the Operational Setup menu
(p.2.2 F2) as required.
OPERATION MANUAL Multicam LSM 11.02
2. Working Interfaces 15