EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 57)

Command Description
ALT+Z:>ARCHIVE Allows the operator to flag a clip to place it in the archive queue of
the XFile defined in the Operational Setup menu (p.7.1 F1) or in
the Setup screen. (The EVS Xfile is a 2U device with 2
removable hard drives, that can be connected to the XNet SDTI
network. Clips can be archived to/restored from the removable
media.)
When a clip is flagged for archiving, but has not yet been
archived, its ID will be blinking green in the Clip screen. It is
permanently highlighted green when the archiving of the clip is
completed.
Depending on the mode selected with the F2 key (CLIP/CAM),
the >ARCHIVE flag is assigned only to the camera angle of the
clip selected with the green cursor (CAM mode), or to all camera
angles of the clip (CLIP mode).
PGM X Located in the bottom right corner of the clip screen, this field is
only visible if the Call channel VGA function has been enabled in
the Operational Setup menu (p.9.2 F4) or in the Setup Screen,
and is only effective in CAM mode, not in CLIP mode. It allows
the operator to select on which channel clips called using the
keyboard/tablet and VGA should be loaded.
Press ALT+F1 on the keyboard to select PGM1, ALT+F2 for
PGM2/PRV, ALT+F3 for PGM3, etc. This function is useful to
load clips on channels that cannot be controlled by an EVS
Remote Panel, or to allow an AP to browse clips on a play
channel not used by the main operator. Note that if that channel
is in PLST EDIT mode with a PRV, the clip will automatically cue
up on the PRV.
OPERATION MANUAL Multicam LSM 11.02
4. Clip Management 47