EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 27)

PLAY
This function initiates a forward motion. It can also be used to start playback of playlists
and clips (refer to PLST command).
When PgmSpd/Var Max is OFF, the default playback speed when pressing the PLAY key
is 100% for standard pictures, 33% for Super Motion pictures with a Triple Speed camera
(SD), and 50% for Super Motion pictures with a Double Speed camera (HD),.
When PgmSpd/Var Max is ON, the value defined in the Operational Setup menu for the
PGM Speed/Var max parameter (p.9.1 F3) is used.
Goto TC
This function allows you to jump to a given timecode in the loaded train or clip.
How to Go to a Given Timecode
To go to a given timecode, proceed as follows:
1. Press SHIFT+GOTO TC key on the Remote.
The GOTO TC window is displayed on the Remote Panel :
Go to TC xx:xx:xx:xx
[Menu] : Cancel
[Enter] : Go to TC
Reset FromDate To Date
Return LTC
2. To specify a date from which the search should be executed, press SHIFT+C, enter
the date in the format dd/mm/yy, using the F1 to F10 keys, and press ENTER on the
Remote.
3. To specify a date up to which the search should be executed, press SHIFT+D and
enter the date in the format dd/mm/yy using the F1 to F10 keys and press ENTER on
the Remote.
4. To specify whether to go to a LTC, USER timecode or any of both (LTC/USER),
press C until the requested timecode type is displayed.
5. Enter the requested timecode using the function keys F1 to F10.
Eight digits: hh:mm:ss;ff (f=frame) are displayed on the LCD screen of the Remote.
◦ If you enter all 8 digits, Multicam will automatically go to the required timecode.
◦ If you enter less than 8 digits (when the last digits are zeros), press ENTER on the
Remote to validate the entry and reach the requested timecode.
Once you have entered the Goto TC, you can observe it has been correctly entered on
the display of the Remote LCD screen and on the output monitor. This Timecode
display appears in the centre of the LCD display, just above the menu options.
6. Press ENTER on the Remote.
OPERATION MANUAL Multicam LSM 11.02
2. Working Interfaces 17