EVS XT3 MulticamLSM Version 11.02 - July 2013 Operation Manual - Manual (Page 124)

Changing the Audio or Video Effect Duration
Introduction
When you change the video or audio effect duration, you extend or reduce the duration of
the video or audio transition:
• In case of Center on cut, the transition is extended/reduced on both sides. This
creates an audio delay or advance depending on whether you reduce or extend the
transition duration.
• In case of Start on cut, the transition is extended/reduced at its end point.
• In case of End on cut, the transition is extended/reduced at its start point.
How to Change the Video Effect Duration
To change the video effect duration, proceed as follows:
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press SHIFT+A Base (A).
4. Press to highlight V Fx Dur (C).
5. Move the lever to adjust the value.
114 5. Playlist Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013