Recording hci traffic – Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual User Manual
Page 102
92
BTTracer Protocol Analyzer User’s Manual
CATC
SW Version 2.20
To capture the data, the HCI Probe should be connected to the respective
'Host to Controller' and 'Controller to Host' lines. When the recording of the
IUT's HCI is enabled and the application starts a recording, the serial data is
captured as incoming serial data. For this, up to two COM ports should be
configured for each IUT.
Probe setup is described in Section 2.8, “Installing the HCI Probe” on
page 18.
Recording HCI Traffic
To capture the data, the HCI Probe should be connected to the respective
'Host to Controller' and 'Controller to Host' lines. When the recording of the
IUT's HCI is enabled and the application starts a recording, the serial data is
captured as incoming serial data. For this, up to two COM ports should be
configured for each IUT.
Step 1
Connect the IUT to the PC that is running BTTracer
following the steps outlined in the previous section.
Step 1
Click the down-arrow on the Record button and
select IUT HCI.
This is the only recording mode supported by BTTracer. This mode configures
BTTracer to exclusively record HCI traffic from IUTs.