Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 113)

103
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
Payload Length Error
Indicates that the payload of a received Bluetooth data packet was either
longer than expected, or that a Bluetooth data packet terminated before the
expected end of the payload data.
Sync Loss
When set, indicates that a loss of piconet synchronization occurred during
the frequency slot prior to this slot.
External Input Signals
Selecting "External Input Signals" causes the analyzer to trigger an external
signal is received through one of the ports on the back of the analyzer (Data
In/Out or Ext. In). If you are using the 25 pin Data In/Out port, connect a
cable from that port to a Break-out Board. Then connect pins on the
breakout board to a signal source.
Breakout Board (Edge Triggered)
The following names are derived from pins on the CATC-provided breakout
board.
• Input 0 (TRIG IN 0) - Selectable Edge triggered inputs. Will
trigger on any edge it detects. Note that only Data1 - Data0 can
be recorded into the trace.