Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 183)

173
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
Step 2
Click OK
The changes you have made are applied and the information is displayed in the
Slave Encryption Setup dialog box as shown previously.
Step 3
Click OK.
The Slave Encryption Setup dialog box closes. Within the Device List, you
should see a "Yes" in the Security field for the selected device.
11.11 Re-applying Encryption Settings
If you record a trace with the wrong encryption settings, the trace will not
decrypt properly. BTTracer lets you correct the problem by re-applying
encryption settings after a recording is finished.
To correct an improperly decrypted trace file, perform the following steps.
Step 1
With the trace open, open the Device List by selecting View
> Device List from the menu.
The Device List opens.
Step 2
Follow the directions outlined above in Section 11.10,
“Encryption” on page 170 for adding/editing encryption
settings.
Step 3 Once the new encryption settings have been applied, run the