Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 55)

45
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
Inquiring... - The system is performing an Bluetooth Inquiry
Syncing to [XXX]... -- The system is attempting to synchronize to a piconet
where the device with BD_Address XXX is the master.
Synced to [XXX] - The system is synchronized to a piconet where the
device with BD_Address XXX is the master.
Monitoring[BTTrainer] - in case the BTTrainer application is active, the
system monitors its Bluetooth activities
Recording [XXX] - system is recording the Bluetooth traffic of the piconet
where the device with BD_Address XXX is the master. Or, it is recording
the traffic of the BTTrainer, in case the BTTrainer is active.
After the analyzer has synchronized to the Bluetooth piconet under
observation, the Status Bar will display activity bars and the strength (in
dBm) of the radio signal that BTTracer is receiving. The activity bars will
increase or decrease with activity. The signal strength readings will display
as five possible values:
• below -60 dBm
• - 60 dBm
• - 50 dBm
• - 40 dBm
• above - 40 dBm
The valid range for a signal is between -60 and - 40 dBm
Search Status
The rightmost segment displays the current search direction: Fwd (forward)
or Bwd (backward).
Zoom In
Zoom In increases the size of the displayed elements, allowing fewer (but
larger) packet fields per screen.
• Click on the Tool Bar.
Zoom Out
Zoom Out decreases the size of the displayed elements, allowing more (but
smaller) packet fields per screen.
• Click on the Tool Bar.