Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 15)

5
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
To capture the data, the HCI Probe can be used respective 'Host to
Controller' and 'Controller to Host' lines. When the recording of the IUT's
HCI is enabled and the application starts a recording, the serial data is
captured as incoming serial data. For this, up to two COM ports should be
configured for each IUT.
1.5 Features
General
• Flexible design - reconfigurable hardware for future enhancements.
• User friendly - the Graphical User Interface software of BTTracer
Analyzer is designed to be consistent with the ‘CATC Trace’ using color
and graphics to display Bluetooth traffic.
• Radio Level Point of Observation and Capture - traffic capture at the
Radio Level for comprehensive analysis.
• Works in combination with the BTTrainer Exerciser.
• Supports two BTTracer probe modules - for recording two piconets and
mixed piconets made up of 1.1 and 1.2 devices.
• Supports two channel recording.
• Complies with Bluetooth v1.2 specification - but can run in both v1.1 and
v1.2 modes.
• Supports point-to-point and point-to-multipoint Bluetooth piconets.
• Supports 79 frequency hop standards, reduced and fixed frequency.
• Automatic tracking of changes in the hopping scheme.
• Automatic tracking of whitened and non-whitened packets and traffic.
• Supports recording of serial HCI traffic from implementation under test
(IUT).
• Free non-recording, view-only software available.
• Power-on self-diagnostics.
• Internal 100V to 240 V AC power supply.
• Compliant with FCC class A requirements / meets all CE mark
requirements.
• Three year warranty and hot-line customer support.
Physical Components
Note For an updated description of requirements for the host machine, please refer to
the readme file.