Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 20)

10
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
B Red Status indicator LED for UPAS (lights during initialization/power
up of UPAS base unit. Blinks if a self-test fails).
C Green REC (recording) LED (lights when the unit is recording).
D Orange TRG (triggered) LED (lights when the unit triggers on an event).
E Green SYNC (Synchronize) LED (Flashing indicates that the analyzer is
tracking the defined slave or master device. Illuminated indicates that
the analyzer is tracking an active piconet.)
F Manual Trigger push-button (allows a manual Trace capture).
G Green REC (recording) LED (lights when the unit is recording).
H Orange TRG (triggered) LED (lights when the unit triggers on an event).
I Green SYNC (Synchronize) LED (Flashing indicates that the analyzer is
tracking the defined slave or master device. Illuminated indicates that
the analyzer is tracking an active piconet.)
J Manual Trigger push-button (allows a manual Trace capture).
2.3 UPAS Rear Panel Description
Figure 1: Rear Panel
From left to right, the UPAS rear panel has the following connectors and
switches:
USB type "B" host computer connector
This is the connector that is used to link the analyzer to the PC that will be
administering it.
RS-232 25 pin "Data Output" Connector
This connector attaches to a 25 pin RS-232 cable that in turn attaches to an
External Breakout board. The breakout board allows signals to be sent from
the analyzer to an external device such as an oscilloscope.
BNC Connectors "Ext. In" and "Ext. Out"
These connectors allow BNC cables to be attached to the analyzer for the
purpose of triggering on external input signals and for monitoring raw
Tx/Rx data.