Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 75)

65
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
If you selected only the second option in Step 12 (=’Passive Sync &
Record’), the following screen will display.
This screen asks you for the address of the Page Target device -- which
in this case is BTTracer. Since the devices in your piconet are not able
to respond to inquiries, BTTracer will not be able to page the devices and
join the piconet. Instead, you will assign BTTracer an address here in
this screen, then direct your piconet Master device to connect to
BTTracer. The Master will attempt to connect to BTTracer and therein
give BTTracer the information it needs to record the Master and slave
devices.
Step 13
Type in an address of your choosing for BTTracer (= Page Target).
You are making up an address for BTTracer that the Master will use to
try to connect to BTTracer.