Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 85)

75
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
6. Recording Options
While the Recording Wizard provides a "walk through" process for setting
the recording options, you can get a more detailed view and set more
parameters through the "Recording Options" dialog box. The Recording
Options dialog box presents all of the settings needed to make a recording.
Once you have selected your recording options, you then select the
recording mode by clicking the down-arrow on the Record button and
selecting from the three mode options: Piconet, Inquiry, and BTTrainer.
BTTracer will then use the relevant Recording Options for the selected
mode. For example, if you select Piconet recording mode, BTTracer will
use the options from the Piconet page in the Recording Options dialog box.
6.1 Recording Modes
Pressing the down-arrow on the Record button displays a menu with four
Recording Modes:
Selecting one of these modes tells the analyzer what sets of Recording
Options it should use when you begin a recording.
Note: Selecting a Recording Mode from the menu does not cause the
analyzer to begin recording. To begin recording, you must press the
Recording button itself.
Piconet recording
Selecting Piconet, configures BTTracer to record piconet traffic using the
parameters set in the Piconet page in the Recording Options dialog box.
When you begin recording in this mode, BTTracer will to try to synchronize
to a piconet that matches the Piconet parameters set in the Recording
Options. The recorded traffic is captured off-the-air.
Note: When BTTrainer is active Piconet mode is disabled as the system is
monitoring the BTTrainer's activity
Inquiry recording
This mode configures BTTracer to record Inquiry traffic. When setting the
BTTracer to Inquiry recording, the system is ready to perform a Bluetooth
'General' or 'Dedicated' inquiry, according to the parameters specified in the