Teledyne LeCroy BTTracer_Trainer - BTTracer Users Manual - Manual (Page 54)

44
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.20
• When you click Stop before or after a Trigger Event, the Progress Bar adjusts
accordingly to begin uploading the most recently recorded data.
The Progress Bar fills with color in proportion to the specified size and
actual rate at which the hardware is writing and reading the recording
memory. However, the Progress Indicator is normalized to fill the space
within the Status Bar.
Recording Status
During recording activity, the current Recording Status is temporarily
displayed in the next segment. When you activate the Record function, this
segment flashes one of the following messages (depending on the selected
Recording Options):
— Trigger?
— Triggered!
— Uploading
After recording stops,
— The flashing message changes to Uploading data–x% done (x%
indicates the percentage completion of the data uploading process).
— The traffic data is copied to disk (overwriting any previous version of this
file) using the default file name data.tfb or a new name specified in the
Recording options.
To abort the upload process,
• Press Esc on your keyboard
OR
Again click in the Tool Bar.
You are prompted to choose whether to keep the partially uploaded data or to
throw it away.
When the data is saved, the Recorded Data file appears in the main display
window and the Recording Status window is cleared.
• If the recording resulted from a Trigger Event, the first packet following the
Trigger (or the packet that caused the Trigger) is initially positioned second
from the top of the display.
• If the recording did not result from a Trigger Event, the display begins with the
first packet in the traffic file.
Analyzer Status
The third segment in the status bar displays analyzer status. The status will
display one of the following:
No Sync - the system is not synced to any piconet