Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 218)

Chapter 9: Reports USB Protocol Suite User Manual
204
LeCroy Corporation
Using the Legend to Set the Priority of Information Display
You can use the legend to set the priority of information displayed in the Pre/Post Trigger
Traffic Type panes. This is a two-step process.
Step 1 For a particular item in a pane, click the column next to the checkbox
for the item. That labels the item as currently active.
Step 2 Next, use the up-down at the lower-right of the area to move the item
higher or lower in priority.
In the case of the Traffic Type pane, priority determines display priority of each packet
type. For portions of the trace that are dominated by a particular packet type, this setting
no effect: only the color corresponding to that packet type is displayed in that portion of
the pane. Suppose, however, that part of the trace includes equal or near equal numbers
of several types of packets. In that case, you can use the legend to select which among
those types is represented in that portion of the Traffic Types pane. This allows you to
view only packets of interest in crowded portions of the trace display.