Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 72)

Chapter 3: Installation USB Protocol Suite User Manual
58
LeCroy Corporation
3.5.3 IP Settings (Voyager only)
If connected to a device, you can change the IP settings:
• DHCP automatically assigns an IP address. DHCP is the default.
• Static IP prompts you to enter a specific IP address.
To change from DHCP to Static IP while connected to a device:
Step 1 Select Setup > All Connected Devices from the menu bar to display the
Analyzer Devices dialog.
Note: If you are not connected to a device, the IP Settings command is grayed out.