Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 246)

Chapter 10: Recording Options USB Protocol Suite User Manual
232
LeCroy Corporation
10.1.3 Options for USBTracer/Trainer and Advisor
• Beep When Trigger Occurs: See above.
• Auto-Merge 2 Channel Trace Files: Causes USBTracer to merge traffic of
the two recording channels into a file called data_merged.usb (or whatever
name you give it). USBTracer also makes two other files during this recording:
data_0.usb and data_1.usb (or whatever names you choose). If unchecked,
USBTracer creates only two files: one for Classic-Speed traffic and another
for Hi-Speed traffic
• Save External Interface Signals: Causes USBTracer to save signals from a
Breakout Board (pins Data7 - Data0) as fields in the trace
• Trigger/Filter Channel: Select 0 or 1. The selection tells USBTracer what
channel it should use to perform its triggers/filters. If you want to set
triggers/filters on both channels, then you must select a channel, assign
trigger/filter events and actions, then select the other channel and assign
trigger filter events and actions to it. In other words, you must set your events
and actions twice - once for each channel. The channel to which you are
currently applying the triggers/filters is shown in the Dialog Title Bar.
10.1.4 Recording Channels (Voyager and Advisor T3)
Voyager: You can select USB 2.0 and/or USB 3.0 as the recording channel. Both can be
captured simultaneously.
Advisor T3: You can select USB 2.0 or USB 3.0 as the recording channel. Only one
of these can be captured at a time.