Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 364)

Chapter 13: Updates USB Protocol Suite User Manual
350
LeCroy Corporation
13.3.4 Manual Updates to Firmware, BusEngine, and
Serdes BusEngine
You can manually update the Firmware, BusEngine™, and/or Serdes BusEngine by
performing the following steps:
Step 1 Select Setup > Update Device on the Menu Bar to display the Update Device
dialog:
The dialog shows the Device Name, Type, Current Version, Required Version,
Status, and File Name.
Note: Updating the CATCSync Bus Engine can take up to 40 minutes. For that
reason, it is recommended that you do not update it when its current status
is "OK".
Step 2 To update the Firmware, BusEngine, and/or Serdes BusEngine, first select its
check box.
Step 3 Click Update Selected or click Update All to update all three.
Note: The most current files were copied to your \LeCroy\USB Protocol Suite
directory when you installed the program.
Step 4 Power cycle the Analyzer. Re-initialization takes a couple of minutes.