Teledyne LeCroy USBTracer_Trainer - Users Manual User Manual
Page 77
USB Protocol Suite User Manual
Chapter 3: Installation
LeCroy Corporation
63
To add a device, click Add to display the USB3 Device -> Analyzer ->
Host Signal Parameter Profiles dialog.
The dialog allows you to Set Device “Current” or Read from Analyzer.
The dialog allows you to Set Host “Current” or Apply to Analyzer.
You can enter Device to Analyzer Signal Settings:
•
Device Name
•
Device Cable ID
•
Input Signal Equalization (ISE) Settings: Short, medium and long time
constant (Current, Off, Minimum, Moderate, or Maximum)
•
Pre-Emphasis Settings: Short and long time level (0 to 15) and
short and long time decay (0 to 7)
•
Output Power Level: Current, or 213 mV to 1294 mV
You can enter Host to Analyzer Signal Settings:
•
Host Name
•
Host Cable ID
•
Input Signal Equalization (ISE) Settings: Short, medium and long time
constant (Current, Off, Minimum, Moderate, or Maximum)
•
Pre-Emphasis Settings: Short and long time level (0 to 15) and
short and long time decay (0 to 7)
•
Output Power Level: Current, or 213 mV to 1294 mV
You can also Load the default settings or Load the last applied settings.