Teledyne LeCroy ArbStudio - Manual (Page 135)

Operator’s Manual
922244-00 Rev A 127
B
Adding a bus
Add a signal to the list by entering the desired name in the Bus or Signal
Name field and then clicking the Add bus or signal button. Now, select the
newly added Bus or Signal showing in the list on the left of the screen,
select the Ch you wish to associate the new Bus or Signal with, and then
click the Add signals to bus button.
Removing a signal or a bus
Remove a signal or a bus by selecting the row or rows on the left for
removal and clicking the Remove bus or signal button.
Editing a signal or bus name
Edit a signal or a bus by selecting the row on the left for edit, making your
name changes in the Bus or Signal Name field, and then clicking the Edit
current bus or signal button
Acquisition - Using The Pattern Generator as a
Sampler
The Digital Pattern Generator can also be used as a Sampler. All acquired
data is stored into a file. This information can be exported, or accessed
from the Waveform View and State Listing screens.
The acquisition command is the WriteRAM vector. When acquisitions run
high, the Digital Pattern Generator stores data on its memory (up to
1,048,576 samples).
The Waveform View Screen
Access the Waveform View, by double clicking Waveform View from the
Device Control tree.