Teledyne LeCroy ArbStudio - Manual (Page 74)

ArbStudio
66 922244-00 Rev A
Component Type
The Type menu allows selecting the component among a list of possible
signals or functions.
Depending on the selected Type, different parameter may be edited. The
different possibilities include the following:
Type Available Parameters
DC Level Offset [V]
Sine Frequency[Hz/cycles], Amplitude[V], Phase[°], Offset[V]
Cosine Frequency[Hz/cycles], Amplitude[V], Phase[°], Offset[V]
Triangle Frequency[Hz/cycles], Amplitude[V], Phase[°], Offset[V]
Rectangle
Frequency[Hz/cycles], Amplitude[V], Phase[°], Offset[V],
Duty Cycle [%]
Saw tooth Frequency[Hz/cycles], Amplitude[V], Phase[°], Offset[V]
Increase Ramp Amplitude[V], Offset[V]
Decrease Ramp Amplitude[V], Offset[V]
Pulse Amplitude[V], Delay[s], Width[s], Offset[V]
Sinc Amplitude[V], Offset[V], Peak Position[s], Lobe Width[s],
Exponential Frequency[Hz/cycles], Vo[V], Vinf[V], Time Constant[s]
Sweep
Amplitude[V], Offset[V], Start Frequency[Hz], Stop
Frequency[Hz]
Formula Calculator Window
From File Explorer Window
The Formula type allows defining the component by means of a
mathematical expression.
The component is edited by using the Formula Editor window that can be
activated by clicking the Edit Formula button. The mathematical expression
can be a function of time or a function of samples by using the t or x
variables, respectively.
The software verifies, in run time, that the component to be edited does
not exceed the limits for the selected output and that the formula syntax is
correct. In case of error, an error indication is shown in the Error message
indicator.